Description
de Havilland Chipmunk In Military Service Part 2 (9)
de Havilland Chipmunk T.10, WP914/’E’ of 6 Air Experience Flight, Royal Air Force Volunteer Reserve, based at RAF Benson, UK, 1979.
de Havilland Chipmunk T.10, WZ877/’75’, of 7 Air Experience Flight, Royal Air Force Volunteer Reserve, based at RAF Newton, UK, 1995.
de Havilland Chipmunk T.10, WK517, ’84’, of 11 Air Experience Flight, Royal Air Force Volunteer Reserve, based at RAF Leeming, UK, 1987.
de Havilland Chipmunk T.10, WB654/’14’, of 10 Air Experience Flight, Royal Air Force Volunteer Reserve, based at RAF Woodvale, UK, 1990.
de Havilland Chipmunk T.10, WD310/’H’, of Elementary Flying Training Squadron, Royal Air Force, based at RAF Barkston Heath, UK, 1988.
de Havilland Chipmunk T.10, WD353/’S’, of Birmingham University Air Squadron, Royal Air Force Volunteer Reserve, based at RAF Shawbury, UK, 1968.
de Havilland Chipmunk T.10, WK517, ’84’, of East Midlands University Air Squadron, Royal Air Force Volunteer Reserve, based at RAF Newton, UK, 1973.
de Havilland Chipmunk T.10, WK642 of Cambridge University Air Squadron, Royal Air Force Volunteer Reserve, based at RAF Woodvale, UK, 1960s.
de Havilland Chipmunk T.10, WP860, of Leeds University Air Squadron, Royal Air Force Volunteer Reserve, based at RAF Church Fenton, UK, 1969.
For best results these decals should be applied to a gloss surface such as provided by either Xtracolor or Xtraacrylix paints. Cut out the decal and soak in warm water until the decal is released from the backing paper. Wet the area to be decaled with Micro Set which will help it to eliminate air trapped under the decal and position the decal.
After 5 or 10 minutes we the decal with Micro Sol which will soften the decal and ensure that it settles down over any surface detail. Allow the decal to dry for at least 12 hours. During this time some wrikling of the decal may occur, this is normal. Do not touch the decal at this time. Carefully check for small air bubbles and if there are any prick with a needle and apply a drop of Micro Sol. After all air bubbles have been eliminated and the decals are dry wash the entire model with water to remove any excess decal adhesive.
When completely dry the whole model should by sprayed with a coat of Xtracolor or Xtraacrylix Flat, Satin or Gloss varnish depending on the finish required.
Store in a cool dry place, avoid sunlight, dampness or extremes or temperature and/or humidity.
Reviews
There are no reviews yet.